Jetstream Lighting Driver Errors

[sic0048]

I'm running CQC 4.3.914. I now get an error when I try to write to the jetstream driver. This happens in the admin interface as well as my actions. Here is a screen shot of the error.



For example, I get an error turning the light on, but it will turn on after several button presses. Same thing turning it off, it gives an error, but will turn off the light after a couple of button presses.

I've also attached a log file. It seems that CQC accepts the actual command if you press the button enough times even though it throws an error. In this log, I turned a light on, and then turned it back off again. I received errors on every button press, and it took several presses to get the light turned off.

[Dean Roddey]

I don't see anything particular enlightening in the log, though you should probably pause the Sage driver until you update it to a working one since it's repeatedly trying to load and failing to compile.

What value are you sending to the driver?

[sic0048]

I swear I had done that before. But it was not paused when I check it after seeing those logs.

[sic0048]

The errors occur when I send a lamp receptical controller the command to turn on to 99. (The field values are 0 to 99). I also sent it the command to go to value 0. So nothing complicated at all. These errors also occur when using the admin interface, so it is clearly a driver issue and not some bad logic in my interfaces.

Again, this definitely worked fine before upgrading to the version I am on. I realize it isn't the latest beta, so if you think it might be something that was already fixed, I'll switch to the latest. (I was waiting to get through the CQC Hangout last night).

But I also think the command is being accepted eventually, so maybe it is a timing issue or something about the math in the driver has changed in the new betas and it has messed something up. Those are just two guesses on my part however.