RadioRA2 Visor Control Receiver - Input support

[gReatAutomation]

Dean, any chance we can add the two Inputs from the Visor Control Receiver to the RadioRA2 driver? Listed on page 137 of the Integration Protocol manual.

These are the two Contact Closure Inputs (CCI) used for a variety of things and will allow us to get the state of the contact closure.

[Dean Roddey]

Those were just added a bit back, right?

[gReatAutomation]

Hey Dean. The Contact Closure Output (CCO) was added but not fields that show the actual status of Input 1 (component 32) or Input 2 (component 33).

[Dean Roddey]

Oh, OK. I'll have to look at that again.

[gReatAutomation]

Hey Dean. Wanted to follow up on this. Hey Dean. The Contact Closure Output (CCO) was added but not fields that show the actual status of Contact Closure Inputs (CCI): Input 1 (component 32) or Input 2 (component 33).

Also for the Contact Closure Output (CCO) itself, it is always in a TRUE state. So, to initiate it, you have to change it from FALSE and back to TRUE. Just making sure this is the intended functionality.

[gReatAutomation]

Hey Dean. Were you able to have a look at this?

[Dean Roddey]

Not yet, I've had other things going on.

[gReatAutomation]

Hey Dean. Any updates on this?

[Dean Roddey]

No, I have things torn up at the moment working on Linux support stuff. It's too much to try to keep getting it back together on a short cycle. So I'm trying to get more done at once, so that I don't spend more time trying to make sure I've not broken something than breaking things.

[gReatAutomation]

Could we start a moderated thread with these things for easier tracking so we are not always asking for updates? Happy to help in this regard as we do not have a JIRA instance