Lutron RadioRA2 Driver and Lutron Visor Control

[Dean Roddey]

So I'm not seeing any discrepancy between the driver's reported set point values and the ones shown on the thermo, either when setting them via the thermo interface or via the driver. I've been running them up a degree at a time, which would show up any rounding issue at some point when it hit the needed magic value, and they continue to agree.

There is a five second delay or so since the thermo doesn't immediately set the new set point. It waits until it's pretty sure you aren't going to make another change. But then it sends outs the value and they seem always agree for me.