11-16-2016, 07:31 PM
You will need to configure it properly to send out information. Select it and use the client side driver's auto-configuration button to send it configuration info. Then you will need to make it wake up, which will allow the driver to send out that queued up configuration data (it's battery powered so the driver can only talk to it when it wakes up.)
Waking up doesn't mean causing motion, it requires that you push a button inside of it or removing and re-add the batteries. I forget the details but look at the docs. When you put the batteries in it wakes up, so that's always a safe way. You can do it after you send the auto-config. The driver knows it is battery powered so it queues those commands up until the module sends a wake up notification.
This assumes the V2 driver of course.
Waking up doesn't mean causing motion, it requires that you push a button inside of it or removing and re-add the batteries. I forget the details but look at the docs. When you put the batteries in it wakes up, so that's always a safe way. You can do it after you send the auto-config. The driver knows it is battery powered so it queues those commands up until the module sends a wake up notification.
This assumes the V2 driver of course.
Dean Roddey
Explorans limites defectum
Explorans limites defectum