Official RIVA thread

[batwater]

I am now running .16 release and 1.09 of taRiva. Phone I am working with is an HTC EVO LTE connecting via WiFi

After rebooting everything due to the .16 upgrade I tested my taRiva connection it worked as expected. Prior to connected I turned on the log monitor for observation. Upon the initial taRiva connection the only thing logged, again as expected, was in increase in the high water mark.

I then left taRiva up and switched to another application which I used for approximately 5 minutes and then returned to taRiva I saw packet sequence and exception errors being logged. taRiva was unresponsive.

I rebooted the phone and was able to connect immediately to CQC via taRiva.

I exited taRiva via the exit command and then tried to go back in at which point errors were again showing up in the CQC log.

At this point after the 2nd phone reboot taRiva will not connect to CQC.

Logsnap attached. logcat from android phone (after 2nd reboot) emailed directly to Fonceur

edit1:

I can confirm the clean exit, won't reconnect behavior on a 2nd phone. taRiva starts up and, in this case, went to the initial template but after that no template activity/interaction possible, just a spinning circle at the bottom. (this on a Galaxy Nexus, android 4.04)

Thanks,
-Ben