12-23-2008, 07:58 AM
Yes I have a gas fired heater and conventional A/C unit, both units are single stage.
On the HAI, I do have an Elk M1 Gold (Yet to be installed, but hopefully soon). I did run a Cat5e cable to all 3 thermostats in the house in addition to the wire that was run (which I was assuming was 4 conductor cable but it may be different than that - will check when I get home). so if I went that way, could I use the CQC Elk driver to monitor and control it?
What are the advantages of going through the Elk .vs. CQC for any of the three choices (RCS, Aprilaire, and HAI)?
On the HAI, I do have an Elk M1 Gold (Yet to be installed, but hopefully soon). I did run a Cat5e cable to all 3 thermostats in the house in addition to the wire that was run (which I was assuming was 4 conductor cable but it may be different than that - will check when I get home). so if I went that way, could I use the CQC Elk driver to monitor and control it?
What are the advantages of going through the Elk .vs. CQC for any of the three choices (RCS, Aprilaire, and HAI)?