5.5 Beta Discussions Thread

[gReatAutomation]

Most of that looks fine. It's just the driver saying that the thermostat hasn't talke to me in a while I'm going to ping it to make sure it's still there and it is. The errors at the end look like you are trying to write to the field from the driver monitor tab and that's failing? What value where you trying to write? It looks like it didn't like the value.

I am simply trying to change the set point. Here is the thermo, set at 78 (High Set Point). The Heating (Low Set Point is showing bot 77 in the thermo and the driver). Trying to make a change in either set points from the driver or from an IV results in the driver going to all ????. What is Lutron Error Code=4?




And here is what the driver is displaying (High Set Point of 79 versus thermo value of 78).