Charmed Quark Systems, Ltd. - Support Forums and Community
Zwave thermostats - Printable Version

+- Charmed Quark Systems, Ltd. - Support Forums and Community (https://www.charmedquark.com/vb_forums)
+-- Forum: General Discussion (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=3)
+--- Forum: CQC Support (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=9)
+--- Thread: Zwave thermostats (/showthread.php?tid=8250)



Zwave thermostats - potts.mike - 04-04-2013

What zwave thermostats are people successfully using with the vrcop? I had a RCS unit that was serial that worked great but moved into an apt. So I need something wireless.


Zwave thermostats - potts.mike - 04-05-2013

I'm going to assume this means no one is using a zwave thermostat with CQC.


Zwave thermostats - Dean Roddey - 04-05-2013

Some folks are, since they were testing it when I was adding that functionality.


Zwave thermostats - sic0048 - 04-05-2013

Sorry, I'm using a serial RCS unit myself (which I love too).


Zwave thermostats - Dean Roddey - 04-05-2013

You might post in the Leviton driver thread.


Zwave thermostats - jaydonoghue - 04-08-2013

I have 3 Trane z wave thermostats in use now. I dont have the model number handy, but they are a few years old


Zwave thermostats - potts.mike - 04-08-2013

Thanks for chiming in Jay, what fields are available with the driver and the Trane thermostats?


Zwave thermostats - Bugman - 04-09-2013

jaydonoghue Wrote:I have 3 Trane z wave thermostats in use now. I dont have the model number handy, but they are a few years old

I've been shopping for thermostats on ebay, I think these are RCS TZ45 OEM units. I went the Zigbee route with a RCS TZB45. For some reason a bunch of these units are being cleared out.

Bugman


Zwave thermostats - jaydonoghue - 04-09-2013

potts.mike Wrote:Thanks for chiming in Jay, what fields are available with the driver and the Trane thermostats?

For each thermo, the following fields are present
CurTemp -> Read only
FanMode -> Write only
FanState -> Read only
Mode -> Write only (set heat/cool/etc)
State -> Read only (what its currently doing)

Setting temperatures is done as follows
Devices::FieldWite(devicename.Command, SetSetPnt "ThermoName" "Mode (Heat|Cool)" "temperature" F)