+- Charmed Quark Systems, Ltd. - Support Forums and Community (https://www.charmedquark.com/vb_forums)
+-- Forum: General Discussion (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=3)
+--- Forum: Installation/Configuration (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=10)
+--- Thread: Problem setting up UPB driver (/showthread.php?tid=8069)
Problem setting up UPB driver - bbrendon - 01-11-2013
I can't get it working though it works fine with UPstart. How can I further troubleshoot this?
I have the demo installed and I'm trying to get one UPB device working. Its a UML-E-W lamp module. I successfully got it working with Upstart with com3. I saved the configuration, closed UPstart, restarted CQC.
CQC driver statistics say (and are increasing):
Failed writes = 68
Loss Comm Res = 67
Driver state toggles : Wait for comm resources and wait for connect
Filename:
C:\Program Files (x86)\CQC\CQCData\MacroFileRoot\Drivers\UPB\UPB.csv
Contents:
NETWORK,22,1,2,,
DIMMER,1,0,DEV-Dim1,,
EOF,,,,,
Problem setting up UPB driver - bbrendon - 01-11-2013
I figured it out.
The serial port is configured as my logged in user. I changed CQC to run as my user account and it works.
Thanks for making me write out my problem which probably caused me to figure it out.
