Charmed Quark Systems, Ltd. - Support Forums and Community
Configure Elk Function Keys - Printable Version

+- Charmed Quark Systems, Ltd. - Support Forums and Community (https://www.charmedquark.com/vb_forums)
+-- Forum: General Discussion (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=3)
+--- Forum: CQC Support (https://www.charmedquark.com/vb_forums/forumdisplay.php?fid=9)
+--- Thread: Configure Elk Function Keys (/showthread.php?tid=10969)



Configure Elk Function Keys - kblagron - 12-27-2019

I have an Elk Function Key (F4) that I use to toggle the non-alarm voice announcements on and off.  How would I use the Elk->InvokeCmd to perform that same function?  I currently have the voice announcements controlled using Output 100.  If it is on, then I disable voice announcements, if it is off, you can hear them over the speakers.


RE: Configure Elk Function Keys - Dean Roddey - 12-28-2019

Wouldn't you just turn that output on/off via the associated field?


RE: Configure Elk Function Keys - kblagron - 12-29-2019

(12-28-2019, 08:55 AM)Dean Roddey Wrote: Wouldn't you just turn that output on/off via the associated field?

That was it - its been so long since I looked at the Elk, I forgot you have to use the Client driver to set the Output 100 field before you see it in the driver.

Thanks,Blake