Omni all zone lights off/on command

[Dean Roddey]

So a number of folks have asked for this command to be added. Supposedly, each 8th unit in the Omni represents the overall room and you can turn all lights on/off in that room via that unit, and that you can also set one of four pre-set scenes. But I don't see anything about this in the Omni protocol document. Obviously I could provide an InvokeCmd type option to write to a unit that is divisible by 8 (+1) without it having to be a defined unit. But how would you set the scenes? It would seem that this would require a special command but I'm obviously not seeing it.

Anyone know anything about this?

[DaveB]

Dean - THis is from the docs;

NOTES:
1. When configured, each House Code will affect 2 rooms of HLC or Vizia RF Z-Wave lighting (i.e. HC 1 ALL ON affects Room 1 and 2).
2. When the House Code is configured as UPB, RadioRA, or CentraLite, Unit Enable All On does not affect the state of the installed devices; however, if this setup item is set to Yes, the HAI Controller will change the status of all units on that House Code to "On" (even though it doesn't explicitly send an All On command to those units). If the Unit Enable All On setup item is set to No, the HAI Controller will not change the status of units on that House Code.

Rooms are in groups of 8 and house codes are in groups of 16. There are a total of 16 house codes (A through P)

I do not think that this is exposed in the latest protocol.